Configuring Switch Settings (Advanced); Event - FLIR DNR500 series Instruction Manual

15 Using the Main Menu
3. Configure the following:
• SMTP Server: Enter the SMTP server address.
• Port: Enter the port used by the SMTP server.
• Anonymous: Check if your server supports anonymous log ins. Otherwise, leave
this unchecked.
• User Name: Enter the SMTP user name.
• Password: Enter the SMTP password.
• Receiver: Enter the email address that will receive alerts.
• Sender: Enter the sender's email address.
• Subject: Enter the subject line for the email alert.
• Attachment: Check to include a jpg image attachment of the camera.
NOTE
You must enable the Snapshot option for motion detection on each camera you would to receive
attachments. For details, see 15.3.8 Configuring Motion Detection, page 57.
• Encrypt Type: Select SSL or TLS if your server uses encryption. Select None if
your server does not use encryption.
• Event Interval: Enter the interval between alert emails.
• Health Enable: Check to enable health check emails. Health check emails will be
sent periodically to ensure that the system is functioning normally.
• Interval: Enter the interval in minutes for health check emails.
4. Click Test to send a test email.
5. Click OK to save settings.

15.3.6 Configuring Switch Settings (Advanced)

You can configure the networking settings for the internal PoE switch.
CAUTION
It is recommended to leave this menu on the default settings. Changing the information in this menu
may disrupt the connection to the cameras.
To configure switch settings:
1. From live view, right-click and select Main Menu.
2. Click >Network>Switch Settings.
3. Configure the IP Address, Subnet Mask, and Gateway for the internal PoE switch.
4. Click OK. Click Save to save changes. The system will restart.

15.3.7 Event

The Event menu allows you to configure settings for motion detection, video loss, and
system warnings.
#LX400023; r.30361/30361; en-US
56