Configuring Alarm Output Devices; Record - FLIR DNR300 SERIES Instruction Manual

14 Using the Main Menu
To configure system error actions:
1. Under Event Type, select one of the following system errors to configure: No Disk,
Disk Error, Disk No Space, Net Disconnection, IP Conflicted, or MAC Conflicted.
2. Check Enable to enable warnings for the selected Event Type.
3. Configure the following actions that will be taken when errors occur:
• Show Message: Check to show pop-up window with information related to the
error.
• Send Email: Check to enable email message. You must configure email alerts be-
fore you will be able to receive them.
• Buzzer: Check to enable system buzzer.
4. Click Save to save changes.

14.4.6 Configuring Alarm Output Devices

You can connect alarm output devices (not included), such as sirens or strobe lights, to
the system. The Alarm Output menu allows you to enable or disable alarm output devices
and manually activate a device.
To control alarm output devices (not included):
1. From live view, right-click and select Main Menu. Log in if prompted.
2. Click Advanced>Alarm Output.
3. To enable alarm output devices, select Schedule or Manual for each device you
would like to enable. Select Stop to disable the alarm output device.
4. Click OK to save changes.

14.4.7 Record

The Record menu is used control manual recording for connected cameras.
The Record menu is divided into the following sections:
• The Record Mode section defines settings for the main (high quality) recording stream.
• The Substream section defines settings for an optional lower quality recording stream.
This is useful because you can record the substream to the hard drive and stream it for
playback to remote devices. This saves bandwidth during remote playback.
#; r. 2.0/23094/23094; en-US
53