Confirming The Exasan Raid System Driver In Windows; Confirm Leds On Hba - Accusys ExaSAN User Manual

After installing the ExaSAN RAID system HBA driver on a Windows based host server, confirm
the driver has been properly installed.
Go to Control Panel -> System Properties -> Hardware -> Device Manager (depending on
the version of Windows, the path may vary). If the driver has been correctly installed, the HBA is
listed with the ACS6x identifier (actual name may vary) as Storage Controllers.
Caution
If you see the HBA listed as an unknown device under Windows, follow
the driver installation steps to reinstall the driver. If you do not see the
HBA under Device Manager, Windows does not detect the card. Power
off the host server to reseat the HBA.

3.2.3 Confirm LEDs on HBA

Verify the Link and Access LED on the backplane of the HBA are appropriately lit according to
your installation (Refer to Section 1.5.2 ExaSAN QSFP Host Bus Adapter). Onboard LEDs of
Z2M indicate more link status, please refer to the Appendix A FAQ Q3.
User Guide
3.2.2.2 Confirming the ExaSAN RAID system driver in
Windows
device manager in Windows platform
3. Installation
Page 3-10