Table of Contents
Advertisement
Chapter 2 – Before you begin
RAID 5 and RAID 5+hot spare
RAID 5 uses a mathematical expression that compares data from three drives and calculates
a fourth piece of data called "parity" which is saved on a fourth drive. Should one of the drives
fail, parity data can be used to rebuild the failed data. Under RAID 5, parity data is stored
across all drives in the array. This maximizes the amount of storage capacity available from all
drives in the array while still providing data redundancy. RAID 5 requires at least three drives.
The ACUTA allows users to set RAID 5 with three drives and the fourth drive as a "hot spare"
ready to be used for rebuilding data in case one of the other drives fails. This is RAID 5 +hot
spare function.
RAID 5: Independent data disks with distributed parity blocks
Characteristics:
Each entire data block is written on a data disk.
Parity for blocks in the same rank is generated
on Writes, recorded in a distributed location and
checked on Reads.
Highest Read data transaction, medium Write
data transaction rate.
Relatively low ratio of ECC (Parity) disks to data
disks means high efficiency (compared to other
RAID levels).
Good aggregate transfer rate.
Storage capacity = (No. of disks – 1) ×
(capacity of smallest disk)
In RAID 5, installed drives each are 40 GB, 50
GB, 60 GB, 70 GB, the RAID capacity will be 120
GB.
In RAID 5 + hot spare, installed 40 GB, 50 GB, 60
GB each in disk 2, 3, 4 and installed 70 GB in
disk 1 as hot spare disk, the RAID capacity will
be 80 GB.
Recommended use:
File
and
application
servers
Database servers
WWW, E-mail and News
servers
Intranet servers
Most versatile Raid level
19
Advertisement
Table of Contents
