Set Video Length; Set Triggering Interval Time; Set Pir Sensitivity - ScoutGuard SG560-8M User Manual

Pocket Camera SG560-8M
b) Press UP or DOWN to select Capture Number.
c) Press RIGHT to select 3 Images.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.

4.1.8 Set Video Length

Press RIGHT to decreases or increases the value by 1 second.
The following shows how to set video length to 5 Seconds provided that the previous
value is 1 Seconds:
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Video Length.
c) Press RIGHT to increase to 5 Seconds.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and exit.

4.1.9 Set Triggering Interval Time

This parameter means that how long the PIR (Passive Infrared motion sensor) will be
disabled after each triggering in ON mode. During this time the PIR of the device will not
react to the motion of human (or animals). The minimum interval is 0 second, it means the
PIR works all the time. The maximum interval is 1 hour, it means the PIR will be disabled
for 1 hour after each triggering. The default value is 1 minute.
Press RIGHT to decreases or increases the value by 1 second or 1 minute.
The following shows how to set triggering interval time to 5 Minutes provided that the
previous value is 1 Minute.
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Interval.
c) Press RIGHT to decrease or increase to 5 Minutes.
d) Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.

4.1.10 Set PIR Sensitivity

This parameter defines the sensitivity of the PIR. There are four parameters: High,
Normal, Low and PIR off. The default value is "Normal". The higher degree indicates that
the Camera is more easily to be triggered by motion, taking more pictures or recording
more videos. It is recommended to use high sensitivity degree in room or environment
with little interference, and to use lower sensitivity for outdoor or environment with lots of
interference like hot wind, smoke, near window etc. Furthermore, the sensitivity of the PIR
is strongly related to the temperature. Higher temperature leads to lower sensitivity.
Therefore it is suggested to set a higher sensitivity for high temperature environment.
It is recommended to use Normal mode. The following shows how to set PIR
sensitivity as Low provided that the previous option is Normal.
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Sense Level.
4 Advanced Operations
10
Page