Table of Contents
Advertisement
Figure 11. Inserting slides into the rack rails
8. Optional step: If the right and left rack mount brackets are installed on the
9. Continue with initial setup of the switch by following the procedures in
18
SAN32B-E4 Installation, Service, and User Guide
b. Check the alignment of the slides by sliding the switch in and out of the
rack. Any difficulty moving the switch indicates lateral stress or
misalignment. If this situation occurs, adjust the slide positions until the
movement is smooth.
front corners of the switch, attach both brackets to the cabinet rack by using M5
x 12 screws 7 . See step 4 on page 16 and Figure 7 on page 14. The screws
should pass through the front of each bracket and the slide rail.
Note: Some rack mount kits might use 10-32 nut clips in place of the M5 nut
clips for the locking ears.
"Configuring the switch" on page 19.
Attention: Do not connect the switch to the network until you perform one of
the following steps:
v Set the internet protocol (IP) address.
v Verify that the default IP address does not conflict with the existing IP
addresses in the same network.
SJ000049
Advertisement
Table of Contents
