WALL MOUNT POWER INJECTOR INSTALLATION (FIG. 4)
1. Make all connections as shown.
The Wall Mount Power Injector:
• Can be mounted in most standard electrical boxes.
• Requires a +12 Volt DC power source. (Inadequate voltage may cause the green LED to not illuminate and the unit to not
function properly.
• Requires #10-12 female spade connectors for power and ground connections.
• Has an internal fuse rated @ 400 mA max. If tripped, the fuse will reset when the circuit cools.
• Is not an amplifier. No devices other than those shown below should be connected.
FIG. 4
IMPORTANT!
Make sure Power Injector is turned off
(button not depressed)
while making connections.
Page 5