Advertisement
OVERVIEW (FIG. 1 & 1-A)
NOTE: Please read thru the instructions before beginning.
1. Verify contents and familiarize yourself with the parts (FIG. 1).
IF YOUR ROOF IS LESS THAN 5" THICK,
PROCEED TO THE NEXT PAGE.
You only have to install the supplied longer connector
for roofs 5" to 6 1/2" thick.
If using the longer connector, install it now,
BEFORE INSTALLING BASE MOUNT ON ROOF (FIG. 1-A).
• Remove the existing adjustable connector from the upper
connector located in the base mount.
• Line up the tab with the shorter side as shown at right and engage
the longer connector onto the upper connector.
• Leave connector sticking out of base mount more than the
thickness of the roof.
IMPORTANT!
The point of the base mount must
face towards the front of the vehicle.
IMPORTANT!
There are two lengths of adjustable
connectors included.
For roof thicknesses 1 1/2" to 5"
use the assembly as shipped.
For roof thicknesses 5" to 6 1/2"
use the longer connector.
IMPORTANT!
You must install
the included
wall mount switch
KC# PB1000
to operate the
KING Jack
antenna.
(See page 5)
FIG. 1-A
Page 2
IMPORTANT!
For roofs 5" to 6 1/2" ONLY!
FIG. 1
Advertisement
