Table of Contents
Advertisement
The control will return to Normal Operation Mode (green indicator) automatically if a button has not been operated
for a period of one minute whenever one of the three adjustment modes have been accessed.
NORMAL OPERATION
To dispense ice, hold a cup directly under the ice chute, then press the appropriate size button on the ice portion
control. To obtain a full cup of ice, press the increase button followed by the appropriate size button. The ice
portion control will not dispense ice and will display a flashing green indicator light if sufficient ice is not available
in the ice chute to dispense the selected size. The indicator light will return to solid green and ice dispensing will
resume after the ice chute has been filled.
The amount of ice dispensed for each size is changed in the Normal and Extra Ice Adjustment Modes. To access
the adjustment modes, press the decrease and increase button at the same time. The control will advance to the
next mode in the sequence as shown in the table on page 3 and the indicator light will change to identify which
mode is currently active.
CLEAN MODE
Access this mode to empty all the ice in the chute. To enter clean mode, press the decrease and increase buttons
at the same time. The indicator light will alternately display red and amber. To empty the ice chute, press any of
the size buttons. The ice gate will then open to allow the ice chute to empty. The ice gate will automatically close
after the ice has been emptied.
To return to normal operation, press the increase and decrease buttons at the same time; then press both buttons
three times in sequence. The indicator light will show amber, red, amber flashing, and finally green to indicate
normal operation.
NORMAL ICE PORTION ADJUSTMENT
From the Normal Operation Mode (green indicator), press both the decrease and increase buttons at the same
time twice. The amber indicator verifies that the normal portion adjustment mode has ben accessed.
To change the amount of ice dispensed, press and hold down the size button for the desired size to be changed.
While holding the size button, press the decrease or increase button to decrease/increase the ice portion size.
When the minimum ice portion adjustment has been reached, the indicator will flash at a slow rate; at the
maximum adjustment, the indicator will flash at a fast rate. After releasing the size button, the indicator light will
flash green for five seconds. During this time period a sample can be obtained to check the portion size by
pressing the size key. The indicator light will return to amber (normal portion adjustment mode) after the sample is
dispensed.
The indicator light will flash red after dispensing a sample, if an open circuit exists in the ice gate cylinder switch
wiring to the ice portion control or if an ice gate binding condition occurred during the sample. The indicator light
will display solid red briefly after a sample is dispensed if the ice gate cylinder switch was shorted.
To return to normal operation press the decrease and increase buttons at the same time, press twice.
EXTRA ICE PORTION ADJUSTMENT
The adjustment of Extra Ice Portion is accomplished in the same manner as ice portions, except the indicator light
displays red. To access this mode press both the decrease and increase buttons simultaneously three time from
the Normal Operation Mode (green indicator). The indicator will display red.
620919540
4
Hide quick links:
Advertisement
Table of Contents
