Removal Of Dvd Deck Parts - Onkyo DV-SP404 Service Manual

2. REMOVAL OF DVD DECK PARTS

NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the
disassembly is done. If the repair is needed except
listed parts, replace the DVD MECHA ASS'Y.
2-1: TRAY (Refer to Fig. 2-1-A)
1. Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
Unlock the 2 supports 1 and draw it while sagging the
2.
Tray.
Push to Sag 1
Tray
NOTE
1. In case of the Tray installation, install them as the circled
section of Fig. 2-1-B so that the each markers are met.
2-2: TRAVERSE ASS'Y (Refer to Fig. 2-2-A)
Remove the screw 1.
1.
Unlock the 2 supports 2.
2.
3. Remove the Insulator (R) from the Loader Sub Ass'y.
4. Remove the Traverse Ass'y.
Loader Sub Ass'y
Traverse Ass'y
• Screw Torque: 2.0 ± 0.3kgf•cm
DISASSEMBLY INSTRUCTIONS
Loader Ass'y
1
Push to Sag
Fig. 2-1-A
Loader Ass'y
Tray
Fig. 2-1-B
1
2
2
Insulator (R)
Fig. 2-2-A
NOTE
1. In case of the Traverse Ass'y, install it from (1) to (4) in
order. (Refer to Fig. 2-2-B)
In case of the Traverse Ass'y installation, hook the wire
2.
on the Loader Ass'y as shown Fig. 2-2-C.
Loader Ass'y (Bottom Side)
(3)
(2)
(4)
2-3: LOADING MOTOR PCB ASS'Y/ LOADING BELT
(Refer to Fig. 2-3-A)
1. Remove the Loading Belt.
Remove the screw 1.
2.
3. Remove the Loading Motor PCB Ass'y.
Remove the 2 screws 2.
4.
5. Remove the Loading Motor.
6. Remove the Gear Pulley.
Loading Belt
• Screw Torque: 2.5 ± 0.3kgf•cm (Screw 1)
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw 2)
B2-1
(3)
(3)
(3)
(1)
(4)
Check Lock
Loader Ass'y
Check Hook
2
2
Loader Sub Ass'y
Gear Pulley
Loading Motor
Loading Motor PCB Ass'y
1
Rack Loading
Holder Traverse
Traverse Ass'y
Fig. 2-2-B
Fig. 2-2-C
Fig. 2-3-A