Onkyo DV-SP404 Service Manual page 22

NOTE
1. In case of the Clamper Ass'y installation, install
correctly as Fig. 2-5-B.
Plate Clamper
Clamper
2-6: HOLDER TRAVERSE/INSULATOR (F)/INSULATOR
(R) (Refer to Fig. 2-6-A)
1. Remove the Holder Traverse.
2. Remove the 2 Insulator (F).
3. Remove the Insulator (R).
Traverse Ass'y
Insulator (F)
Holder Traverse
NOTE
1. In case of the Insulator (F) installation, install correctly
as Fig. 2-6-B.
Insulator (F)
2-7: SWITCH PCB ASS'Y/GEAR MIDDLE/GEAR FEED/RACK
FEED ASS'Y/FEED MOTOR (Refer to Fig. 2-7-A)
Unlock the support 1.
1.
2. Remove the Gear Middle.
Remove the screw 2.
3.
4. Remove the Rack Feed Ass'y.
Remove the screw 3.
5.
6. Remove the Switch PCB Ass'y.
Remove the screw 4.
7.
8. Remove the Gear Feed.
Remove the 2 screws 5.
9.
10. Remove the Feed Motor.
11. Remove the Gear Motor.
DISASSEMBLY INSTRUCTIONS
Check Lock
Fig. 2-5-B
Insulator (R)
Insulator (F)
Fig. 2-6-A
Traverse Holder
Fig. 2-6-B
Traverse Ass'y
Rack Feed Ass'y
• Screw Torque: 1.3 ± 0.3kgf•cm (Screw 2)
• Screw Torque: 3.0 ± 0.3kgf•cm (Screw 3)
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw 4, 5)
NOTE
1. When installing the Rack Feed Ass'y, push both ends to
align the teeth as shown Fig. 2-7-B. Then install it.
2. In case of the Gear Motor installation, check if the value
of the Fig. 2-7-C is correct.
3. When installing the wire of the Switch PCB Ass'y, install
it correctly as Fig. 2-7-D.
Manual soldering conditions
• Soldering temperature: 320 ± 20˚C
• Soldering time: Within 3 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
4. After the assembly of the Traverse Ass'y, hook the wire
on the Traverse Ass'y as shown Fig. 2-7-E.
Push
Gear Motor
Feed Motor
B2-3
Feed Motor
Gear Motor
5
1
5
Gear Feed
4
Gear Middle
2
Switch PCB Ass'y
3
Rack Feed Ass'y
[OK] [NG]
8.0 ± 0.2mm
Safety surface for pressing
of the insert.
Fig. 2-7-A
Push
Fig. 2-7-B
Fig. 2-7-C