Installing The Accessories; Installing The Firestones - Montigo P42DF Installation & Maintenance Manual

P42DF* Indoor Gas Fireplace
Section 8: Installing the Accessories

Installing the Firestones

The P42DF* is supplied with firestones. Remove the
Door as shown in the previous Instruction. Follow these
instructions to ensure all parts are removed or replaced
as required. Once the Trim and glass door is removed
place the firestones randomly across the pan and the
burners as described in Figure 22 to 22f.
Note: Only cover the burner with one layer of designer firestones.
Figure 22.Up-lighting glass in package.
Figure 22a Place the up-lighting glass in the burner tray.
Figure 22b Installation of the firestones. (Ensure ONLY one
layer of firestones cover the surface).
Figure 22c. Spreading the firestones evenly and make sure
there are no firestones covering the pilot .
Page 20
Installation
Figure 22d. Completed firestone installation.
Figure 22e. Completed firestone installation. (Note: DO NOT
place ANY firestones on top of the pilot cover).
Figure 22f. Gas fireplace with firestones surrounding burner
tray.
If the firestones are not placed properly (ONE LAYER ONLY),
on burners excessive sooting will result. The firestones will
get very hot while the fireplace is in operation, and should
not be handled until cool.
If the pilot cover is covered with firestones it may result
in delayed ignition and/or damge to the appliance and/or
surrounding property.
CAUTION!
WARNING!
XG0195 - 030712