7 • Service Menu & Troubleshooting
7.2.18 OMR / Acc Wetter constant
This function performs the same function as Basic Wetter Constant, but when OMR/ Acc is used
it contacts the envelope earlier to allow for sealing of thicker packages.
•
DI425/SI3500 = 25
•
DI380/SI3300 = 55
7.2.19 T1 clutch Release Time
This adjustment is basically a stop position for the envelope depth. European flap depths are typically
deeper than standard or US envelopes. For deeper envelope flaps increase the number.
Standard setting for USA envelopes is 112.
Standard setting for European envelopes is 122.
7.2.20 T2 envelope Hold Time
Default setting is 0. This adjustment is basically the Envelope Hold time. Set to a slightly higher
figure if the glue needs longer to break down.
•
DI425/SI3500 = 0 (Safe Seal Clutch), 1 (Without Safe Seal Clutch)
•
DI380/SI3300 = 0 (Safe Seal Clutch), 1 (Without Safe Seal Clutch)
7.2.21 T3 Table Offset
Default setting is 0. Do not change this setting. The software measures the number of pages in
collation in order to determine whether or not the envelope should be held in the sealer area or
not.
•
DI425/SI3500 = 0
•
DI380/SI3300 = 0
See OMR Template.
7.2.22 OMR Offset Feeder 1
•
DI425/SI3500 = 125
•
DI380/SI3300 = 125
7.2.23 OMR Offset Feeder 2
·
DI425/SI3500 = 115
·
DI380/SI3300 = 115
7-4
(Swiss Offset = 165)
(Swiss Offset = 165)
SDT333A DI380/DI425/SI3300/SI3500 Service Manual