Belling GOURMET 900 DF Service Manual page 33

We recommend that this appliance is connected by a com-
petent person, who is a member of a recognised
"Competent Persons Scheme" and who will comply with
local regulations.
The appliance must be installed using a multi-pole control
unit of 13 Ampere minimum capacity with 3mm minimum
contact separation at all poles, which must remain acces-
sible after installation.
Ensure that you route all mains electrical cables well clear
of any adjacent heat source, such as an oven or grill.
Where a fixed connection is used, a device allowing the
G
appliance to be isolated on all poles from the mains sup-
ply with a contact opening width of at least 3mm must
be provided.
After connection to the electricity please check that all
G
electrical parts are working.
The maximum power rating is specified in the Technical
G
Data section of this handbook, and also on the Data
Badge on the appliance.
Connecting the electricity supply
Warning: This appliance must be earthed!
Access to the mains terminal is gained by removing the
G
terminal block cover at the rear of the appliance - use
a pozi N 2 screw driver for this.
o
Connection should be made with a minimum 1.5mm
G
twin and earth cable.
First strip the wires. Then push the cable through the
G
cable clamping the terminal block cover.
Connect the cable to the terminal block and tighten the
G
cable clamp screw - see diagram.
Replace the cover.
G
Sufficient cable should be used to allow the cooker to
G
be pulled out, but must hang clear of
the floor so it does not become twisted
or trapped when the cooker is pushed
back.
Installing Your Cooker
2
NEUTRAL BLUE
EARTH GREEN/YELLOW
LIVE BROWN
30