Belling GOURMET 900 DF Service Manual page 31

The information below is crucial to installing this appliance
correctly and safely.
Gas Safety (Installation & Use) Regulations
This appliance must be installed by an authorised person in
accordance with the manufacturers installation instructions,
local gas fitting regulations, the AGA Gas Installation, the
Australian Gas Installation Code AS5601 and any other rele-
vant statutory regulations.
Particular attention should be given to relevant requirements
regarding ventilation.
Failure to install appliances correctly is dangerous
and could lead to prosecution.
Fitting the plinth (if applicable)
Make sure the appliance is raised to a height of 915mm
G
or above before beginning. If the appliance is below
915mm - you can only fit the plinth cover labelled Y.
You can adjust the height using the feet (1) of the
appliance.
If your appliance has a storage drawer at the bottom,
you access the required holes through the base of the
drawer after lifting the mat.
Open the appliance doors, and loosen screw A located
G
on bracket (2). Do not remove this screw entirely.
Insert screw B, through slot (3) and screw into the small
G
hole at the bottom of bracket (2).
Make sure that the plinth cover is flush to the appliance,
but not over tightened.
Installing Your Cooker
28
Oven cavity
Door
(1)
X
(3)
B
Y
Plinth cover
A
(2)