Washer Fluid Check; Technical Specifications - Ford Ranger Owner's Manual

For item location: See Under Bonnet
Overview (page 145). See Under Bonnet
Overview (page 147).
1. Switch the ignition off.
2. Connect and secure a suitable hose on
the filter drain plug.
3. Route the other end of the hose to the
suitable container.

TECHNICAL SPECIFICATIONS

Vehicle fluids
Part
Engine oil - Diesel (for
markets with low sulphur
content
less than 350 ppm)
Engine oil - Diesel (for
markets with high sulphur
content
greater than 350 ppm)
Engine oil - Petrol
Ranger (TKE) Vehicles Built From: 03-12-2012, Vehicles Built Up To: 31-12-2013
Maintenance
4. Loosen the drain plug by approximately
1.5 turns.
5. Switch the ignition on to activate the
in-tank pump.
6. Drain the water till it is replaced by a
clean diesel fuel.
7. Switch the ignition off.
8. Tighten the drain plug and remove the
hose.
9. Start the engine and check for leaks.
Note: The water-in-fuel indicator lamp will
go out after approximately 2 seconds, with
the engine running.

WASHER FLUID CHECK

Top up the washer fluid reservoir when the
washer fluid level indicator is on. See
Warning Lamps and Indicators (page
58).
When topping up, use a mixture of washer
fluid and water to help prevent freezing in
cold weather and improve the cleaning
capability. We recommend that you use
only high quality washer fluid.
Recommended fluid
Castrol Engine Oil
Castrol Engine Oil
Castrol Engine Oil
152
Specification
WSS-M2C-913-C
WSS-M2C-913-D
WSS-M2C-921-A
WSS-M2C-913-D
WSS M2C913-C
WSS-M2C-913-D