Audio System Security; Security Code - Ford Ranger Owner's Manual

SECURITY CODE

Each unit incorporates a unique code that
is needed to activate the audio system
when the vehicle battery has been
disconnected and reconnected. The 4 digit
code is included in the owner information
pack.
If the security code is not available, please
see your dealer.
Entering a security code
If 'CODE - - - - , 'CODE 0000 or 'Enter
Keycode appears in the display when you
switch on the audio unit, you must enter
the Keycode using the station preset
buttons.
Type 0, 1 and 2
1. Press button 1 repeatedly until the first
digit of your Keycode is shown in the
display.
2. Press preset buttons 2, 3 and 4 in the
same way for remaining three digits.
3. Make sure that the complete Keycode
is correct before pressing preset button
5 to confirm it except 1500RDS press
the AM/FM button.
Type 3, 4 and 5
1. Press the numbered button
corresponding to the first digit of your
Keycode.
2. Press the numbered button
corresponding to the second digit of
your Keycode. Repeat for digits 3 and
4 in the same way.
3. If you make a mistake entering the
code, you may re-enter the digits by
continuing to select buttons 0-9. The
display will advance from digit position
1 to 4 and then back again.
Ranger (TKE) Vehicles Built From: 03-12-2012, Vehicles Built Up To: 31-12-2013

Audio System Security

199
4. Make sure that the complete Keycode
is correct before pressing either the *
preset button or the button between
the arrow buttons to confirm it.