Speedometer Cable Removal; Handlebar Replacement - Eton America Beamer PN2 Service Manual

8.3 SPEEDOMETER CABLE REMOVAL

Remove the handlebar cover.
Unscrew speedometer cable nut.
Unscrew the speedometer cable fixing bolt at the front
wheel. Pull out the worn speedometer cable.
Install a new speedometer cable.
NOTE: Before assembling the new speedometer cable,
apply grease on the inner line of this cable.

8.4 HANDLEBAR REPLACEMENT

Remove the rear view mirrors.
Disassemble the upper cover of handlebar.
Disconnect the speedometer cable and connectors of
switches.
Disassemble the rear brake cable and rear brake lamp
connector near the left handlebar.
Remove the right grip assembly.
Disconnect the throttle cable.
Unscrew the brake master cylinder fixing bolt.
Remove the brake master cylinder assembly.
Beamer Rev-2.0.2 Page 36 of 55 11/21/2005