Wheels And Tires; Gear Oil; Engine Stop Switch - Eton America Beamer PN2 Service Manual

2.10 WHEELS AND TIRES

Inspect the tire surfaces for cuts, nails, or other sharp
objects. Check the tire pressure at cold tire condition.
The standard tire pressure is 2.5±0.3 kgf/cm2

2.11 GEAR OIL

Fill Plug
Transmission gear oil needs to be changed every year
or after every 3000 miles of service.
The drain bolt is located at the rear of engine.
Remove the drain bolt and loosen the fill bolt to drain
the transmission gear box.
Inspect the drained oil for foreign materials. If the oil
contains a high concentration of metal shavings or
powder, disassemble the transmission for further
inspection.
Reinstall the drain bolt and refill the gear box with
Drain Bolt
100cc 3.4oz of SAE 80-90 Gear Oil
/
Note: for best results, drain the transmission while
the engine is warm.

2.12 ENGINE STOP SWITCH

The engine stop switch is located beside the left handle bar.
In an emergency, pushing this switch will stop the engine.
The stop switch must be place in the on position, the top of the
switch pressed down, for the engine to start.
If your engine fails to start, check the switch.
Turn
Beamer Rev-2.0.2 Page 12 of 55 11/21/2005