Eton America Beamer PN2 Service Manual page 34

7.9 DISASSEMBLY AND INSPECTION OF THE C.V.T. SYSTEM
Remove the engine clutch cover by unscrewing the
fixed bolts. Check the belt for wear. If necessary,
replace the belt. Disassemble the front drive pulley
and check the six rollers for wear. If necessary,
replace the rollers.
Remove the screws on the clutch cover at the left side
of the engine. Take off the clutch cover and gasket.
The belt, front pulley and rear pulley are now visible.
Unscrew the front pulley fixing nut. Remove the
front pulley carefully. Take out the six rollers from
the front pulley. Inspect the surface of the rollers. If
there is serious wear, replace with new rollers.
Inspect the belt. If it is broken or loose, replace with a
new one.
Beamer Rev-2.0.2 Page 34 of 55 11/21/2005