Engine Installation - Eton America Beamer PN2 Service Manual

Remove the engine hanger nut.
Remove the rear brake cable adjusting nut.
Pull the engine out from the frame.

3.2 ENGINE INSTALLATION

Install engine in reverse order of disassembly.
Torque value:
M8 nut 15 - 22 lbf-ft
M10 nut 22 - 29 lbf-ft
M12 nut 36 – 43 lbf-ft
After installing the engine, check the parts below:
o All connections (A/C generator,
starter motor, etc)
o Carburetor throttle cable
o Rear brake cable
o Oil tubes and fuel tubes
Beamer Rev-2.0.2 Page 16 of 55 11/21/2005