Eton America Beamer PN2 Service Manual page 60

ETON America, LLC
Service Bulletin
Bulletin No.: SB-0046
Date: 07/26/06
FIG #5
FIG #6
FIG #7
Beamer Luggage box installation
Once the luggage box is installed push the
rear brake light LED wires through the hole
in the box as shown in Fig #5 and install the
luggage box pad.
The wires for the LED hookup are lo-
cated on the rear of the bike around the
rear taillight. They may be tucked in
under the harness on the left hand side of
the unit..
Note: ONLY the Beamer II & III and
the Matrix & Matrix II have been pre
wired for the luggage box brake light.
If you have the older model Beamer the
LED will have to be hard wired into
the rear taillight.
Connect the wires from the LED light to
the main harness using the following
wiring table.:
Box Wires Main Harness
Red Brown
Green Green
Black Black