Eton America Beamer PN2 Service Manual page 39

Bleeder Valve
Engage the front brake a few times by pulling the brake
lever gently. Then, hold the front brake level all the
way in; while holding in, release the bleeder valve on
the front caliper to force the air out. Then, lock the
valve. Repeat this action until no more air flows out.
Torque value: 4 lbf-ft
DISASSEMBLING THE FRONT BRAKE DISK
Disassemble the front wheel.
Unscrew the three brake disk fixing bolts.
Remove the brake disk.
Torque of these M8 nuts: 14 – 22 lbf-ft
INSPECT BRAKE DISK
Measure the thickness of the brake disk.
Standard thickness: 3.6 mm
Limit: 3.1 mm
BRAKE SHOES (LINING) INSPECTION
Measure the thickness of the brake lining.
Standard thickness: 4.0 mm
Limit: 3.0 mm
NOTE: Do not get grease on the lining surface.
Beamer Rev-2.0.2 Page 39 of 55 11/21/2005