Eton America Beamer PN2 Service Manual page 62

ETON America, LLC
Service Bulletin
Bulletin No: 0050
Beamer rear wheel inspection and removal.
Date: 03/01/2007
Put the bike on the center stand and let the exhaust cool down before installation . Then remove the (2)
10mm bolts from the exhaust pipe flange on the bottom of the cylinder. The remove the (2) 12mm bolts
from the exhaust RH side. Once the exhaust is removed then, remove the 24mm wheel nut and washer.
Remove the wheel and replace with a new factory wheel and rim.
Page 1