Table of Contents
Advertisement
2-2 Front Panel LEDs
The following figure shows the front view of the NetComm Cable/DSL Firewall Router.
The LEDs on the front panel indicate the status of the unit.
Power:
Green
Diag:
Red
WAN ports
Link/Act:
Green
Yellow
Green/Yellow Blinking when data is flowing through the LAN port.
FD/Col:
Green
LAN ports
Link/Act:
Green
Yellow
Green/Yellow Blinking when data is flowing through this LAN port.
FD/Col:
Green
www.netcomm.com.au
Page 12
On when power is on.
Lights up during system check when the power is initially
connected. If the Router is working properly, the light should
switch off after the diagnostic has been completed.
On when ADSL/Cable Modem is properly connected and is
operating at 100Mbps.
On when ADSL/Cable Modem is properly connected and is
operating at 10Mbps.
On when operating in full duplex mode.
Off in half duplex mode.
Blinking when a collision has occurred on this port.
On when link is up and is operating at 100Mbps.
On when link is up and is operating at 10Mbps.
On when operating in full duplex mode.
Off in half duplex mode.
Blinking when a collision is occurring on this port.
Rev.2 - YML630
Cable/DSL Firewall Router
Advertisement
Table of Contents
