Table of Contents
Advertisement
INSTALLATION CAUTIONS & WARNINGS
DO NOT extend the Remote start ignition harness length. Mount the module so that main harness reaches all ignition
switch wiring. Extending these wires could result in poor or improper performance.
DO NOT route any wiring that may become entangled with brake, gas pedals, steering column or any other moving parts
in the vehicle.
DO NOT exceed the rated output current of any circuit on the Remote start module. Failure to observe this warning will
result in damage to the unit not covered under warranty.
DO NOT remote start the vehicle in a closed garage! Make sure that the garage door is open or there is adequate
ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes.
WIRING Low Current 12 Pin Plug
YELLOW: (-) HORN CHIRP HONK OUTPUT (Programmable 15, 20 or 40 milliseconds)
Connect to the LOW CURRENT Negative Horn Trigger wire usually located near the steering column. If the vehicle horn
circuit requires 12V, then a relay is required. RELAY WIRING: Connect the Yellow wire to terminal #85, connect relay
terminals #86 and #87 to 12V constant power. Connect terminal #30 to the 12V positive Horn activation wire.
BLACK: MAIN SYSTEM GROUND
Connect to chassis metal of the vehicle. An existing bolt or screw may provide an adequate ground, or drill a small hole,
scrape away paint and attach using a sheet metal screw & star washer. This wire must be connected to a proper ground
or undesirable and inconsistent operation will occur. Do not use Factory ground locations.
YELLOW / BLACK: (-) GROUND OUT WHEN RUNNING
The Ground Out when Running output is used for Anti-theft and Transponder Bypass modules. It can be used for a Anti
grind / Starter Disable. This wire turns on when the remote start button is pressed and stays on through the duration of
the remote start. When using this wire for an Anti grind/Starter disable, an optional Relay is needed to interrupt the Starter
circuit. The starter disable circuit prevents accidental grinding of the starter if key is turned too far after a remote start.
This required an optional Diode, see diagrams on NEXT PAGE.
3
Hide quick links:
Advertisement
Table of Contents
