Components And Measurement Values Td60 - Asko TD60 Service Manual

Servicemanual TD60

Components and measurement values TD60

Item number Component
80 618 24 Motor 50 Hz,
220/240 V
80 618 95 Motor 60 Hz,
73 829 92 Capacitor 6 μF
80 546 40 Capacitor 4 μF
88 011 94 Condensing waterpump 25W
80 762 02 EMC filter with inductor
80 762 24 Thermistor
80 792 91 Thermistor
80 773 85 Thermostat/Overheating
protection
(150°C automatic)
80 792 00 Thermostat/Overheating
protection
(135°C automatic)
80 761 04 Door switch
80 761 03 Microswitch float
Electrical connection
88 013 27 Control Unit compl. TD60.3
8080604 Control Unit
8079287 Heating Element 2500W
8079288 Heating element 3000W
29
220/240 V
Measurement value
Main winding: 23.8 Ω
Auxiliary winding: 28.1 Ω
Current: 1.1 A; 270 W; 2850
rpm
Winding resistance:
cable colour grey-blue 25.5 Ω
cable colour grey-red 16.0 Ω
Current: 0.9 A; 200 W; 3300
rpm
111 Ω
4 – 6 kΩ (at room tempera-
ture 20 – 30°C)
8 - 12 kΩ (at room tempera-
ture 20 – 30°C)
Heater 1: 1950W, 24,5Ω
Heater 2: 550W, 91,4Ω
Heater 1: 1950W, 24,5Ω
Heater 2: 1050W, 45,3Ω
Comments
The motor is a 2-pin motor and is directly con-
nected to the fan for internal air and gearing for
driving the cylinder. The fan for external air is also
driven on condenser dryers.
The capacitor is mounted on the motor.
The filter eliminates interference to and from the
machine.
The thermistor controls temperature regulation.
If the thermistor is short-circuited or detaches
from the control unit, the program is cancelled.
The thermostat
/overheating protection interrupts the program
at too high temperatures.
The front door affects a door switch, which inter-
rupts the program when the door is opened. If
the door has been opened and closed during the
program the machine must be restarted using the
start/stop button.
If both containers are overfilled the program is
interrupted by a float switch located on the lower
holder. Overfilling is indicated in the display.
The machine is delivered as single phase and can
be switched between 1950 W, 10 A and 2500
W, 16 A.
Adjustment between 1950 W / 10 A and 2500
W / 16 A is carried out using software via but-
tons.
The control unit contains microprocessors for
controlling programs, motor, element etc.