Component Descriptions; Components And Measurement Values - Asko TD70 Service Manual

Service Manual TD70
Component description

Components and measurement values

The specified resistance values apply at room temperature (about 20°C/68°F). Values within
±10% are considered normal.
Article no. Component
80 839 15 Motor 50 Hz,
220/240 V
80 839 16 Motor 60 Hz,
220/240 V
80 903 13 Capacitor
80 903 14 Capacitor
80 902 70 Capacitor heat pump
80 821 28 Condensate pump
80 846 48 Condensate pump
80 762 02 EMC-filter with inductor
80 833 44 Thermistor
80 902 72 Termostat 150
80 902 73 Termostat 135
80 902 24 Thermostat 110
80 761 04 Door switch
10
Measurement value
Winding resistance:
cable colour red-white 26.5 Ω
cable colour red-blue 53.5 Ω
cable colour white-blue 27.0 Ω
Current: 0.7 A; 140 W; 2850 rpm
Winding resistance:
cable colour red-white 26.5 Ω
cable colour red-blue 53.5 Ω
cable colour white-blue 27.0 Ω
Current: 0.7 A; 140 W; 3300
rpm
8 μF
6 μF
17 μF
4.8 kΩ (at 25°C)
150°C manual reset
135°C manual reset
110°C automatic
Comment
The motor is a 2-pin motor and is
directly connected to the fan for
internal air and the gearing for driving
the cylinder. On condenser dryers, the
motor also drives the fan for external air.
50 Hz
60 Hz
50 and 60 Hz
50 Hz
60 Hz
The filter eliminates interference to and
from the machine.
The thermistor controls temperature
regulation. If the thermistor is short-
circuited or detaches from the control
unit, the program is stopped.
The thermostat/overheating cut-out
stops the program if the temperature
becomes too high.
The front door triggers a door switch
which stops the program when the door
is open. If the door has been opened and
closed during the program the machine
must be restarted using the Start/Stop
button.