Table of Contents
Advertisement
P 370/470 RF Scanner Product Reference Guide
Laser On Time
This parameter sets the maximum time decode processing continues during a scan attempt.
It is programmable in 0.1 second increments from 0.5 to 9.9 seconds.
Scan the bar code below to set a Laser On Time. Next scan two numeric bar codes beginning
on page 5-102 that correspond to the desired time. Time less than 1.0 second must have a
leading zero. For example, to set a Time On of 0.5 seconds, scan the bar code below, then
scan the "0" and "5" bar codes. If you make an error, or wish to change your selection,
scan CANCEL on page 5-104.
Note: Allowing the scanner to stay on longer than originally programmed
may affect the battery life time for that session before needing a
charge.
5-24
LASER ON TIME
Advertisement
Table of Contents
