Table of Contents
Advertisement
Parameter Menus
Laser On Time
Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan
attempt. It is programmable in 0.1 second increments from 0.5 to 9.9 seconds.
To set a Laser On Time, scan the bar code below. Next scan two numeric bar codes
beginning on
page 9-144
that correspond to the desired on time. Times less than 1.0
second must have a leading zero. For example, to set an on time of 0.5 seconds, scan the
bar code below, then scan the 0 and 5 bar codes. To change the selection or to cancel an
incorrect entry, scan the
Cancel
bar code on
page
9-146.
Laser On Time
9-15
Advertisement
Table of Contents
