Replacing The Battery; Charge Status Led Indications - Symbol P 370 RF Reference Manual

P 370/470 RF Scanner Product Reference Guide
2. Slide the battery towards the bottom of the scanner and then pull the bottom of the
battery back and out of the scanner.

Replacing the Battery

1. Place the top portion of the battery (curved side op, contacts toward top) into the
scanner and then slide it up the handle.
2. Replace the battery compartment cover.
3. Slide the release latch up to secure the cover in place.

Charge Status LED Indications

The LED indicator on the cradle uses flashing patterns to display the charger status, as shown
in the table below.
Off
Blinking Slowly
Blinking Rapidly
On
4-4
Figure 4-2. Pulling the Battery Out
Table 4-1. Cradle LED Indications
LED
The scanner is not in the cradle.
The scanner is properly seated in the cradle, but
charging has not begun.
The battery is actively charging.
Battery charging is complete.
Status