Wall Mounting - Symbol P 370 RF Reference Manual

P 370/470 RF Scanner Product Reference Guide

Wall Mounting

Before wall-mounting the cradle, the scanner support tab must be changed from the desk-
mount position to the wall-mount position.
1. Lift the scanner support tab out of the top part of the cradle and replace it in the wall-
mount position.
2. Seat the cables from the bottom of the cradle in the grooves along the length of it so
that the bottom of the cradle is smooth.
3. Fasten the two screws provided into the wall where the cradle will hang, leaving
about 1/8" (0.3 cm) of the screw outside the wall for the cradle's wall mounting
sockets (A template is provided for you in the PL 370/470 Quick Reference Guide
p/n 72-38494-01).
4. Place the cradle over the screw heads and slide down until it fits into place. Slight
pressure upwards should not move the cradle.
2-6
Desk Mount
Figure 2-4. Scanner Support Tab
Cable
Grooves
Figure 2-5. Placement of Cables
Wall Mount