Lexmark MS312 Service Manual page 53

4
Close the rear and front doors.
5
From the printer control panel, press
202 paper jam messages
Error code Description
202.01 Exit sensor is covered during warm up.
202.03 Media did not reach the fuser exit sensor.
202.05 Exit sensor covered too long or exit sensor did not
clear ahead of a sheet.
202.13 Restart attempted after an internal jam without cover
open. Close event. Likely that the jam was not actually
cleared.
202.14 Expected banner sheet ( assumed wide ) not detected
by narrow media sensor, possible accordion jam,
unsupported narrow banner media, or missing signal.
202.16 Page at fuser nip before fuser started ramping toward
desired. Indicates code may be receiving more hall
interrupts than intended.
202.17 Page at fuser nip before fuser reached acceptable
operating temperature. Page arrived at fuser earlier
than expected, so it was probably staged.
202.22 Cartridge Motor - Motor Underspeed Error. Motor
made it to closed loop steady state, but then detected
speed was below threshold.
202.28 Exit sensor bounce issue.
202.32 The sheet is too long to be duplexed. The blow
through is enabled.
to clear the message and continue printing.
Action
Go to
page 54.
Go to
page 54.
Go to
page 54.
Go to
page 54.
Go to
page 54.
Go to
page 54.
Go to
page 54.
Go to
page 54.
Go to
page 54.
Go to
Diagnostic information
53
"Sensor (fuser exit) jam service check" on
"Sensor (fuser exit) jam service check" on
"Sensor (fuser exit) jam service check" on
"Sensor (fuser exit) jam service check" on
"Sensor (fuser exit) jam service check" on
"Sensor (fuser exit) jam service check" on
"Sensor (fuser exit) jam service check" on
"Sensor (fuser exit) jam service check" on
"Sensor (fuser exit) jam service check" on
"Duplex service check" on page
4514
57.