Calling Procedures Outline; Calling Operation - Icom IP100H Instruction Manual

4

CALLING OPERATION

Calling procedures outline

[PTT]
[Option]
Select a desired address book. (p. 4-3)
q
• Push [ ] one or more times.
• Select "All" for all terminals calls, "Group" for group calls,
"Individual" for individual terminal calls or "Telephone" for
telephone calls.
• Selectable address books may differ, depending on the
IP1000C's settings.
Select a desired address (ID) or extension number.
w
(p. 4-3)
• Push [J] or [K] one or more times.
• Selectable IDs or extension numbers may differ, depend-
ing on the IP1000C's settings.
• You can select a desired ID or extension number from the
call history by pushing [
If you want to send a message (p. 4-6), or make an
e
area call (p. 4-9), push [FUNC] one or more times.
• Select "Message" to transmit a message, or "Area Call"
for an Area Call.
• Push [J] or [K] one or more times to select a desired
message.
• Selectable messages may differ, depending on the
IP1000C's setting.
• When Area Call is selected, push [J] or [K] to select
ON.
Push [PTT] to make a call.
r
Hold down [PTT], and speak at your normal voice
t
level.
Release [PTT] to listen.
y
Repeat the steps
u
versation.
To hang up a telephone call, push [Option].
i
• The function assigned to [Option] may differ, depending
on the IP1000C's settings.
• Ask your system manager which function is assigned.
For your information
When the VOX function or full-duplex mode is set in the
IP1000C, steps t and y are not necessary.
When the VOX function is set, speak into the headset
microphone to transmit, then stop speaking to listen.
In full-duplex, you can speak and hear the other person
at the same times.
NOTE: Use one of the following options for full-duplex
operation.
• HM-153LS
• HM-166LS
• HS-85 with OPC-2144
• HM-153 with OPC-2144
• HM-166 with OPC-2144
4-2
]. (p. 4-7)
t and y until you finish your con-