Giving Preference To The Tape Length Over The Title Sequence (Cd Edit) - Kenwood XD-951 Instruction Manual

Giving preference to the tape length over the title sequence
(CD EDIT)
When the tape recording time is specified, recording is ex-
ecuted with changing the title sequence so that no title
will be interrupted when the tape direction is changed at
the end of one side.
When the equalizer or SRS 3D is applied to the
sound, the sound with the applied effect can be re-
corded.
Recording preparations are required. •
1
Press the DUBBING key.
2
Select "CD EDIT" and press the SET key.
1
3
Select a disc and press the SET key.
1
4
Set the tape length (recording time) and press the ENTER key.
1
5
Start edit recording.
Press the ENTER Key.
Press the CD PGM key twice to cancel CD EDIT.
Depending on the combination of conditions from CD contents (number of titles and length of the titles) and tape recording time, interruption
of a title may not be avoidable. In such a case, the respective title will not be recorded.
Note Note
i
• • •
•
(Steps 1 to 3 ) (For the reverse mode, select " p " (two-way recording).)
2
MULTI
CONTROL
SET
2
MULTI
CONTROL
SET
2
MULTI
CONTROL
ENTER
ENTER
When Dolby Pro Logic, Dolby 3 Stereo or DSP mode is selected,
cancel it by pressing the STEREO key of the remote control unit.
CD ONE TRACK RECORD (Only during CD playback)
CD RECORD
CD EDIT
CD PGM RECORD
TAPE DUBBING
(Only when the selected input is TAPE and tapes are
present in both decks A and B)
D s I C
÷ Even if the disc has already been selected, select the disc again.
C -
Automatic editing of tape sides A and B
E N
E D I T
1 2
÷ The tape and CD stop automatically when recording has completed.
÷ Press the stop (7) key to stop recording in the middle.
÷ If you commit an error in the time entry, restart the procedure from step
1.
Convenient CD recording
XD-951/A900/A700 (En)
C D E D I T
2
6 0
T E R
A T 0 1
3
45