Kenwood XD-951 Instruction Manual page 33

4
Check the programmed tracks (and replace, add or delete tracks as required).
To check:
To replace a track in the program:
1 Select the programmed disc or track
to be replaced and press the SET
MULTI
key.
CONTROL
2 Select a disc or track to replace the
disc or track selected above (step 3-
1 and 2).
To add a track to the program:
1 Select the display as shown on the
right and press the SET key.
MULTI
CONTROL
2 Perform the same operations as in
step 3-1 and 2.
To delete a track from the program:
1 Select the programmed disc or track
to be cleared and press the SET key.
MULTI
CONTROL
2 Select "CLEAR" and press the SET
key.
To end the above operation:
5
Start playback.
To quit the program mode
Press twice.
(at an interval of 2
sec. or more)
÷ If you are using the remote control unit, press
the key once again while "CD PGM" is dis-
played.
MULTI
CONTROL
SET
SET
SET
ENTER
6
MENU
Remote
control unit
P 0 1 D 2 T 0 2
÷ The programmed tracks are displayed in sequence.
P 1 2 D 3 T O 4
÷ The blinking item can be replaced.
P - - D - T - -
÷ The added track number is added to the end of the existing program.
P 1 2 0 3 T O 4
P 1 2 C L E A R
To perform an operation in step 4 after ending it, press
the CD PGM key once.
÷ When the 4 or the ¢ key is pressed during play, the program will
jump to the preceding or the following track respectively.
÷ When the 4 key is pressed once during playback, the play position
returns to the beginning of the current track being played.
÷ When the TIME key of the remote control unit is pressed during
playback, the time display appears but it soon returns to the original
display.
P G M 0 1
C D 0 1
÷ If the key is pressed during playback, normal playback in order of tracks
resumes from the current track.
Playback of CD
XD-951/A900/A700 (En)
T O 1
0 O 0
33