Copying Tape (Tape Dubbing) - Kenwood XD-951 Instruction Manual

Copying tape
(Tape dubbing)
The contents of the tape in deck A can be copied onto the
tape in deck B.
1 Select the "TAPE" input.
2 Press the stop key.
3 Select "[" (double-side recording)
or """ (one-side recording).
4 Press the DUBBING key.
5 Select "TAPE DUBBING" and press
the SET key.
1. Select.
6 Use the same tape transport direc-
tions.
(1) Select the transport direction of
deck A.
1. Select.
(2) Select the transport direction of
deck B.
7 Start dubbing.
The DOLBY NR key is not active in dubbing mode. The tape recorded on deck B assumes the same Dolby NR condition as the tape played on
deck A.
Note Note
REV.MODE
2. Press SET.
MULTI
CONTROL
SET
2. Press SET.
MULTI
CONTROL
SET
MULTI
CONTROL
ENTER
Load tapes in the decks.
A
Playing tape
CD RECORD
CD EDIT
CD PGM RECORD
TAPE DUBBING
T
÷ When recording is started, the tape will be transported in the direction
selected in this step.
Check the tape transport direction
indicators.
A
A DIR FWD
A DIR RVS
B DIR FWD
B DIR RVS
RETURN
÷ By selecting "RETURN" and pressing the ENTER key, the operation
returns to the previous step so the current step can be restarted.
÷ Dubbing ends automatically when the side(s) to be dubbed has been
completed.
To stop dubbing
REC/ARM
÷ The deck B will stop after creating a non-recorded portion of about
4 sec, and then the deck A will stop.
÷ Dubbing can also be stopped by pressing the stop (7) key. Note that
the non-recorded space is not created in this case.
Let's record
XD-951/A900/A700 (En)
A
Recording tape
A P E D U B B I
| Scrolled display
(TAPE DUBBING)
D I R F W D
31