JUKI LK-1900B/IP-420 Instruction Manual page 73

No.
Magnet wiper OFF delay time
Wiper output timing selection at the time of UP
dead point stop
: UP position
: UP dead point position
Range of move limit in + X direction
Range of move limit in -X direction
Range of move limit in +Y direction
Range of move limit in -Y direction
X/Y jump feed speed is set
X/Y feed forward/backward speed is
set.
Selection of effective/ineffective of automatic
preparation motion at the time of turning on the
power
: Ineffective
: Effective
Selection of effective/ineffective of needle bar stop
holding mode
: Ineffective
: Effective
Number of pulses of wiper motion
that interlocks the presser
Item
– 69 –
Setting range Edit unit
10 to 500ms 10ms
― ―
−20 to 20mm 1mm
−20 to 20mm 1mm
−20 to 10mm 1mm
−20 to 10mm 1mm
100 to 4000pps 10pps
100 to 4000pps 10pps
― ―
― ―
30 to 60 1
Initial display
100ms
20mm
-20mm
10mm
-20mm
In case of LK-
1901/LK-1903,
the initial display
is -10mm.
2000pps
500pps
45