Service The Parksense® Park Assist System - Jeep 2014 Cherokee Owner's Manual

When the ParkSense® switch is pressed to disable the
system, the instrument cluster will display the
"PARKSENSE OFF" message for approximately five sec-
onds. Refer to "Electronic Vehicle Information Center
(EVIC)" in "Understanding Your Instrument Panel" for
further information. When the shift lever is moved to
REVERSE and the system is disabled, the EVIC will
display the "PARKSENSE OFF" message for as long as
the vehicle is in REVERSE.
The ParkSense® switch LED will be ON when
ParkSense® is disabled or requires service. The
ParkSense® switch LED will be OFF when the system is
enabled. If the ParkSense® switch is pressed, and re-
quires service, the ParkSense® switch LED will blink
momentarily, and then the LED will be ON.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 255
Service The ParkSense® Park Assist System
During vehicle start up, when the ParkSense® System
has detected a faulted condition, the instrument cluster
will actuate a single chime, once per ignition cycle, and it
will display the PARKSENSE UNAVAILABLE WIPE
REAR SENSORS , PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS , or the PARKSENSE UNAVAIL-
ABLE SERVICE REQUIRED message for five seconds.
When the shift lever is moved to Reverse and the system
has detected a faulted condition, the EVIC will display a
PARKSENSE UNAVAILABLE WIPE REAR SENSORS ,
PARKSENSE UNAVAILABLE WIPE FRONT SENSORS
or PARKSENSE UNAVAILABLE SERVICE REQUIRED
pop up message for five seconds. After five seconds, a car
graphic will be displayed with UNAVAILABLE at ei-
ther the front or rear sensor location depending on where
the fault is detected. The system will continue to provide
arc alerts for the side that is functioning properly. These
3