Jeep 2014 Cherokee Owner's Manual page 35

doors and disarm the Vehicle Security Alarm (if
equipped). Then, prior to the end of the 15-minute cycle,
press and release the START/STOP button. If the
START/STOP button is not present, insert the Key Fob
into the ignition switch and turn the switch to the
ON/RUN position.
NOTE:
• For vehicles not equipped with the Keyless Enter-N-
Go™ feature, the ignition switch must be in the
ON/RUN position in order to drive the vehicle.
• For vehicles not equipped with the Keyless Enter-N-
Go™ feature, the message "Remote Start Active —
Insert Key and Turn To Run" will display in the
EVIC/DID until you insert the key. Refer to "Elec-
tronic Vehicle Information Center (EVIC)" or "Driver
Information Display" in "Understanding Your Instru-
ment Panel" for further information.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 33
• For vehicles equipped with the Keyless Enter-N-Go™
feature, the message "Remote Start Active — Push
Start Button" will display in the EVIC/DID until you
push the START button.
Remote Start Comfort Systems — If Equipped
When remote start is activated, the heated steering
wheel, and driver heated seat features will automatically
turn on in cold weather. In warm weather, the driver
vented seat feature will automatically turn on when the
remote start is activated. These features will stay on
through the duration of remote start or until the ignition
switch is cycled to the ON/RUN position.
The Remote Start Comfort System can be activated and
deactivated through the Uconnect® SETTINGS. For more
information on Remote Start Comfort System operation
refer to "Uconnect® Settings" in "Understanding Your
Instrument Panel."
2