Removing A Printer Hard Disk - Lexmark MX810 Series User Manual
Mx810 series
Hide thumbs
Also See for MX810 Series:
- User manual (397 pages) ,
- Quick reference (34 pages) ,
- E-mail manual (4 pages)
Table of Contents
Advertisement
Additional printer setup
Removing a printer hard disk
Note: This task requires a flat‑head screwdriver.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
Warning—Potential Damage: Controller board electronic components are easily damaged by static electricity.
Touch a metal surface on the printer before touching any controller board electronic components or connectors.
1
Access the controller board.
For more information, see
2
Unplug the printer hard disk interface cable from the controller board, leaving the cable attached to the printer
hard disk. To unplug the cable, squeeze the paddle at the plug of the interface cable to disengage the latch before
pulling out the cable.
"Accessing the controller board" on page
27.
44
Advertisement
Table of Contents
