Miele h 6800 bp Operating And Installation Instructions page 136

Problem solving guide
Problem
The message "Fault with
moisture control - the
automatic programmes
will operate without
moisture" appears in the
display after selecting
an Automatic
programme.
After selecting the
Moisture plus d
function "Fault with
moisture control -
Moisture plus
programme not
available" appears in
the display.
Programmes using
moisture will not take in
water.
A noise can be heard
after a cooking process.
The rack and other
accessories make a
noise when being
pushed into or pulled
out of the oven.
136
Possible cause and remedy
The steam injection system is faulty.
^ Call the Miele Service Department.
Automatic programmes can be run without using
moisture.
The steam injection system is faulty.
^ Call the Miele Service Department.
^ Use the Fan plus U function instead of the Moisture
plus d function.
^ Check whether "On" has been selected for demo
mode (see "Settings - Showroom programme").
The oven can be used in demo mode but the pump for
the steam injection system will not work.
^ Deactivate demo mode.
The fan remains switched on after a cooking
programme (see "Settings - Cooling fan run-on").
The pyrolytic resistant surface of the side runners
creates friction when accessories are being pushed
into or pulled out of the oven.
To reduce the friction, add a few drops of heat resistant
cooking oil to some kitchen paper and use this to
lubricate the side runners.
Repeat this after each pyrolytic cleaning process.