Playing Music - Kenwood C-V751 Instruction Manual

Playing music

The following procedure allows to play a MD,CD or cassette
tape.
Preparations
÷ Connect components as described in "System connection".
÷ Complete "Setup of the Graphical Remote Control (GRC)
unit".
1
Press the ON/STANDBY key to ON.
Main unit
ON/STANDBY
2
Select the input source.
Main unit
(Select the icon)
INPUT
÷ Step 3 can be omitted if the easy operation feature is available.
"Easy operation feature"
3
Play the selected source.
Main unit
(Select the icon)
Operation on each
source component
4
Adjust the volume.
Main unit
VOLUME CONTROL
DOWN UP
To To
decrease increase
volume volume
5
@
GRC
ON/STANDBY
GRC
or
™
GRC
CD MD
or
GRC
UP
To increase volume
To decrease volume
DOWN
÷ Load the CD player or cassette deck with the software to be played.
\Read the instruction manuals of the associated components.
With the main unit operation, the input sources are switched as shown below.
1 TUNER (frequency display)
2 CD
3 MD/TAPE 1
4 DVD/DVD 6ch INPUT *1
5 VIDEO 1
6 VIDEO 2
Pressing and holding the AUTO key for more than 2
seconds allows the source to be switched as shown
below.
*1: To change the DVD display to DVD 6ch INPUT or LD
display
To enable system-control operation, the displayed information should
be set according to the actually connected components.
V O L _ 5 ) d B
AUTO STEREO
MEMO. TUNED F M
RDS EON TP A M
PTY TA NEWS MW
LW
MUTE CLIP
÷ Rotating the VOLUME CONTROL at a higher speed increases the
amount of volume change (AI VOLUME function).
÷ The sound of input source cannot be listened to while TAPE 2/
MONITOR is ON.
Sound adjustment
The selected source is displayed.
C D
AUTO STEREO
MEMO. TUNED F M
RDS EON TP A M
MW
PTY TA NEWS
LW
MUTE CLIP
0
Volume level is displayed.
AUTO SOUND DIGITAL DIGITAL
DTS DOLBY DIGITAL
PRO LOGIC 3 ST
MHz SLEEP DOWN
KHz TIMER 1 2 TAPE2/M
•
27