Kenwood C-V751 Instruction Manual page 17

5 Repeat steps 2 through 4 until you have taught GRC all the
commands you want it to know. If you need more lines,
touch or to access more lines.
Programming an additional function which is not dis-
played in the screen
1 Repeat steps 1 and 2 in "To program STOP as a new
control item".
2 Press the "Modify" icon.
3 Press the
or icon to select one of
"Empty 1 to 8".
4 Assign a name to the function.
5 Aim the device's remote at GRC and press and hold the
button on the device's remote that corresponds to the
command you want GRC to learn.
6 Repeat steps 2 through 5 until you have taught GRC all the
commands you want it to know. If you need more lines,
touch or to access more lines.
^
10 cm
Setup of the Graphical Remote Control (GRC) unit
÷ The name can be composed using up to 8 characters.
÷ Touch
to access to lowercase characters. Touch it again to
access special characters (such as @, !, &, etc.). Touch it a third time
to return to uppercase characters.
÷ Touch
or to move back and forth between the characters.
÷ Touch BS (Backspace) to clear the last caracter you entered. Touch
ALL DEL to delete all the characters in the line.
÷ This may take a few seconds; do not move GRC or the device's remote
until GRC displays the Function change menu again.
÷ Be sure to use the device's original remote. GRC will not learn
commmands from other universal remotes.
÷ The additionally programmed function is registered in the
17
area.