Kenwood C-V751 Instruction Manual page 16

16
7 Press the "Code" icon. You can now choose from a list of
all the codes available for the device. Select the first code
on the list.
8 Press the "Check" icon.
9 Press the "Enter" icon.
Set up other components in the same way as above.
Programming remote control functions
Remote control functions of some components may not be available even after the setup codes have been registered. In this
case, required functions can be programmed as if the GRC unit "learns" them.
To program STOP as a new control item
1 Perform steps 1 to 4 in 1.
2 Press the "Modify" icon.
3 Select the function to be programmed.
4 Aim the device's remote at GRC and press and hold the
button on the device's remote that corresponds to the
command you want GRC to learn.
10 cm
Setup of the Graphical Remote Control (GRC) unit
÷ When a code which is not shown in the setup code chart is entered,
the entered code disappears automatically.
÷ Even when the system control code is connected, some models may
not automatically display the "System" screen.
÷ With CD-Carrousel, select "Sys-carrousel".
÷ When CD, MD and TAPE are connected through system control
cords, select "System".
Check the operation of the component.
1 Display the operation screen of the component to be checked.
2 Turn on the component from the GRC and confirm the actual
component.
÷ If there is more than one setup code, select the "Check" icon.
This instructs GRC to send a "Power" test signal to the receiver.
If your device turns on, the code you entered was correct. If it
does not turn on, try the next code in the list. Continue until one
of the codes works.
Although each setup code is designed to work with a
number of different models, certain codes may not work
Note Note
with some models. (Also, certain codes may only oper-
ate some of the functions available on a given model.)
With some models, be sure to keep the Check icon
pressed for a while.
÷ If the device power cannot be turned ON/OFF, return to 7 and select
the net code in the list.
Repeat 7 and 8 until the device power can be turned ON and OFF
properly.
÷ This may take a few seconds; do not move GRC or the device's remote
until GRC displays the the Function change menu again.
÷ Be sure to use the device's original remote. GRC will not learn
commmands from other universal remotes.
Continued to next page