Setting Up The Grc According To Other Components (Set Up) - Kenwood C-V751 Instruction Manual

Setting up the GRC according to other components (Set Up)

In the initial condition, the setup codes for CD, MD and DVD
have already been pre-registered. The GRC can also be used
to remote control other components which are not con-
nected through system control cords.
Registering setup codes for VIDEO 1
1
Enter the setup code.
1 Select the "SET UP" icon.
2 Select the "Preference" icon.
3 Press the "IR" icon.
4 Press the "Input" icon to open the list of available jack
sets.
5 Press the "Device" icon to select the type of device you
have connected to the jack set.
6 Press the "Brand" icon to select the device's brand.
Setup of the Graphical Remote Control (GRC) unit
In the operations of the GRC (Graphical Remote
Control unit), proceed to each step within 10
seconds after the previous step.
The display disappears in 10 seconds.
To resume GRC display, move the Joy-
stick in any directions.
Select the icon with or
1 CD
2 MD/TAPE 1
3 VIDEO 1
4 VIDEO 2
5 DVD/DVD 6CH
6 TV 1
7 TV 2
8 TAPE 2/MONI.
Select the icon with
or
1 CD
2 TAPE
3 MD
4 VCR
5 CABLE
6 SATELLITE
7 TV
8 LD
9 DVD
0 Nothing
.
.
Continued to next page
15