Playing Music - Kenwood C-V351 Instruction Manual

Playing music

The following procedure allows to play a CD, MD, DVD or
cassette tape.
22
Preparations
÷ Connect components as described in "System connection".
÷ Complete "Setup of the Graphical Remote Control (GRC) unit".
1
Press the ON/STANDBY key to ON.
Main unit
ON/STANDBY
2
Select the input source.
Main unit
INPUT
3
Play the selected source.
Main unit
Operation on each
source compo-
nent
4
Adjust the volume.
Main unit
To increase volume
VOLUME CONTROL
DOWN UP
To To
decrease increase
volume volume
RC GRC
POWER
ON/STANDBY
RC GRC
INPUT
Main
Menu
ENTER
C D
ENTER
RC GRC
CD
6
ENTER
ENTER
RC GRC
To increase volume
%
VOLUME
VOLUME
To decrease volume
fi
To decrease volume
5
!
: Keys or controls to be used in this operation
÷ Load the CD player, MD recorder, DVD player or cassette deck with
the software to be played.
\Read the instruction manuals of the associated components.
With the main unit operation, the input sources are switched as shown below.
1 VCR
2 AUX
3 TAPE 1 / MD *1
4 TUNER (frequency display)
5 CD
6 LD / DVD *2
7 6ch INPUT
*1: To change the TAPE 1 display to MD display
*2: To change the LD display to the DVD display
To enable system-control operation, the displayed information should
be set according to the actually connected components.
÷ Note for using the 6ch INPUT
÷ Step 3 can be omitted if the easy operation feature is available.
One-touch operation
Pressing the play key of the CD player, DVD player or cassette deck
starts up the system automatically and starts playback. When this
operation is used, steps 1 and 2 can be omitted.
V O L U M E - 5 )
÷ The time taken till the volume level is displayed is variable depending
on the current operating condition.
÷ Rotating the VOLUME CONTROL at a higher speed increases the
amount of volume change (AI VOLUME function).
÷ The sound of input source cannot be listened to while TAPE 2
(MONITOR) is ON.
C-V351/C-V301 (EN)
AV CONTROL CERTER KC-2
0
¡
Volume level is displayed.
dB
∞
¡