Kenwood C-V751 Instruction Manual page 34

34
2
Set the input mode to DIGITAL AUTO (MANUAL).
Main unit
1 Set the input mode to "DIGITAL AUTO
INPUT MODE
(MANUAL)".
(Select the icon)
3
Select the DIGITAL REC mode.
AUTO REC MODE
Main unit
1 Set the REC mode to "AUTO REC
DIGITAL
MODE".
REC
2 Put the cassette deck (MD recorder) in
record-pause mode.
MANUAL REC MODE
Main unit
Method 1
1 Play the source to be recorded.
DIGITAL
2 Set the input mode to "MANUAL REC
REC
MODE".
3 Apply decoding that matches the input
signal from the source selected and played
in "1" above.
Method 2
1 Set the input mode to "MANUAL REC
MODE".
2 Play the source to be recorded.
3 If audio is not output, switch the decoder
by pressing the LISTEN MODE key.
GRC
Main unit
Each press switches the indication.
1 DIGITAL AUTO
Input signal is detected automatically.
2 DIGITAL MANUAL
Selected input signal is held.
3 ANALOG
GRC
1 DIGITAL AUTO
Input signal is detected automatically.
2 DIGITAL MANUAL
Selected input signal is held.
÷ The switching is not available when the DVD 6ch INPUT is selected.
÷ "3 ANALOG" cannot be selected when the input signal is the DTS
signal.
÷ Each press of
or switches the display between "Source"
and "Destination" alternately.
Main unit
Each press switches the indication.
1 REC MODE OFF
Off
2 AUTO REC MODE
3 MANUAL REC MODE
Switch on the REC MODE to record a digital input source.
Usually use the AUTO REC MODE to record audio input sources.
When the digital mode changes during recording in the AUTO
REC MODE, the audio may be interrupted momentarily. To
record the audio from the beginning of the digital mode change,
use the MANUAL REC MODE.
÷ The input is automatically down-mixed to 2 channels.
÷ Recording is not available when the DVD 6ch INPUT is selected.
÷ The EON overriding does not occur during recording.
÷ For the recording using a cassette deck or MD recorder, read the
instruction manual of the cassette deck or MD recorder.
÷ The LISTEN MODE key can be used to switch the decoder only when
the MANUAL REC MODE is selected.
÷ Sound may not be reproduced when the input signal and LISTEN
MODE are selected improperly.
How to select the digital input, analog input and LISTEN MODE.
Recording
•
•
E
Continued to next page