Chapter 2. Connecting The Router; System Requirements; Installation Environment Requirements; Connecting The Router - TP-Link TL-WR743ND User Manual

Chapter 2. Connecting the Router

2.1 System Requirements

Each PC in the LAN needs a working Ethernet Adapter and an Ethernet cable with RJ45
connectors
TCP/IP protocol must be installed on each PC
Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or later
If the device is configured to AP client router mode, you also need Wireless Internet Access
Service (WISP)
If the device is configured to AP router mode, you also need Broadband Internet Access
Service (DSL/Cable/Ethernet)
One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router is
connected directly to the Ethernet or the Router works on the AP Client Router mode.)

2.2 Installation Environment Requirements

Place the Router in a well ventilated place far from any heater or heating vent
Avoid direct irradiation of any strong light (such as sunlight)
Keep at least 2 inches (5 cm) of clear space around the Router
Operating Temperature: 0 ~40
Operating Humidity: 10%~90%RH, Non-condensing

2.3 Connecting the Router

To connect the Router, please follow the steps below:
1. Power off your PC, Cable/DSL Modem, and the Router.
2. Locate an optimum location for the Router. The best place is usually at the center of your
wireless network. The place must accord with the
3. Adjust the direction of the antenna. Normally, upright is a good direction.
After finishing the steps above, please choose the operation mode you need and carry out the
corresponding steps. There are five operation mode supported by this router: AP Client Router,
AP Router, AP Repeater, AP Bridge and Client.
TL-WR743ND
(32 ~104 )
℃ ℃ ℉ ℉
- 6 -
150Mbps Wireless AP/Client Router
Installation Environment Requirements.