Installation Environment Requirements; Connecting The Device - TP-Link TL-WA701ND User Manual

2.4 Installation Environment Requirements

Place the AP in a well ventilated place far from any heater or heating vent
Avoid direct irradiation of any strong light (such as sunlight)
Keep at least 2 inches (5 cm) of clear space around the AP
Operating Temperature: 0 ~40
Operating Humidity: 10%~90%RH, Non-condensing

2.5 Connecting the Device

Figure 2-3 is an example of an infrastructure network incorporating the TL-WA701ND. An
Infrastructure network contains an access point or a wireless router. For a typical connection of the
device, please do the following:
1. You will need broadband Internet access (a Cable or DSL-subscriber line into your home or
office). Consult with your Cable or DSL provider for proper installation of the modem.
2. Connect the Cable or DSL modem to a Router. Quickly install the router.
3. Locate an optimum location for the device. The best place is usually near the center of the
area in which your PC(s) will wirelessly connect. The place must accord with the
Environment Requirements.
4. Adjust the direction of the antenna. Normally, upright is a good direction.
5. Connect the Ethernet Broadband Router to the TL-WA701ND Access Point. Power on the
Access Point.
6. If you are connecting a desktop PC or laptop to your network, install the TP-LINK Wireless
Adapter on the PC.
Figure 2-3 The Example of Infrastructure Network Incorporating the TL-WA701ND
TL-WA701ND 150Mbps Wireless Lite N Access Point User Guide
℃ ℃ (32 ~104 ) ℉ ℉
5
Installation